XXX-s front end mod, In-board pin angle

There is about 3deg "in-board pin angle" on the front end of a XXX-S built in and that makes front end feel stiff cause that weird angles put pressure on hinge pins.

and I found following paragraphs from JRXS manual

" In-board Pin Angle: The in-board angle of the front hinge pins is adjustable in 1 degree increments from 0 to +2 degrees (angled out).

The car comes with a 0 degree front pivot block. Running more inboard front toe-out (+1 or +2 degrees) will provide a more responsive feel in the steering with less overall steering. Running less in-board toe (0 degree) will result in more stability with more overall steering."

Do I want more stablillity and more steering on my car?

Absolutely!

so i just put a rear suspension block(LOSA9848) on the front to square up the front end to make my car more 21st century car.

but that made my car's front end too narrow, I swapped wheel hex with pair of 0.255" (LOSA9688) to make 190mm front end.

front end feel lot more smoother, springier.