Need all type-r drivers help

I just wrote requesting running change on losi forum regarding lcd and rcd axle pin hole placement, i already mentioned in this blog about aluminium wheel hex adaptor issue and i thought that was my fault as i wrote here

I spent over 30 dollars thought problem solved by having all new hexes and a new wheel nuts about a month ago but this happened again today, then i realized this never happened on my xxx-s before, i measured them side by side and found hole is drilled little bit closer on the type-r as pictured below

this is how to check if you are having a same issue

1. remove hub carrier from the arm
2. mount a wheel on a axle as you normally would and lock nut as you always do.
3. spin the wheel, if it feel grindy or even locked then go to following link and make your voice heard.
4. the link for losi forum to todd hodge, losi production manager