Naked emperor

(I throw few sets away already before taking this picture)

I guess no one having a problem as I do with hexes, or just don't want to admit it, I even posted a picture of axle that drilled too short but no ~

or people already gave up to asking Losi for anything? cause they know nothing going to happen

I'm sick and tired of buying sets of aluminium hexes for $12 per pair or $24 per set of 4, I will just have to run stock plastic hexes until lose few axle pins, get pissed off just to get rid of this step children car.

it's been a full day and I know Todgemoto been in and out of the Losi forum but no answer so far regarding my thread, no explain, no excuse, no admitting or nothing.

or may be Derek B is right about the car "Car is discontinued so there are no updates." Derek works for that RC car magazine which I forgot a name (one with lots of half naked girl holding cars) may be he know what hes talking about after all this years.

Need all type-r drivers help

I just wrote requesting running change on losi forum regarding lcd and rcd axle pin hole placement, i already mentioned in this blog about aluminium wheel hex adaptor issue and i thought that was my fault as i wrote here

I spent over 30 dollars thought problem solved by having all new hexes and a new wheel nuts about a month ago but this happened again today, then i realized this never happened on my xxx-s before, i measured them side by side and found hole is drilled little bit closer on the type-r as pictured below

this is how to check if you are having a same issue

1. remove hub carrier from the arm
2. mount a wheel on a axle as you normally would and lock nut as you always do.
3. spin the wheel, if it feel grindy or even locked then go to following link and make your voice heard.
4. the link for losi forum to todd hodge, losi production manager